Slipper clutch dimensions needed...

[Miggers]

Could someone with an RC10(original version),a Mardave Cobra TQ
or Mad Rat measure up the slipper for me please.

A/ Diameter

B/ Depth from the clutch face(where the spur sits)to the bit where
the shaft goes in/comes out(the flat that the spring presses on).

C/ What material do you think it's made of?Aluminium?,steel?,magnesium alloy?what?

Meaurements in millimeters if possible please.

Cheers.

Mark;)

[Miggers]

Ok,could someone with a modern 2WD buggy measure up the slipper as above please?

Cheers

[isobarik]

What are you after ??? basicly the slipper from the rc 10 and the lazer zxr are the same just turned around regarding where the slipper pad sits.

Are at work can measure it later when im not at work.

mvh Isobarik

[Miggers]

Hiya Iso.

This is what I'm after so that I can get the slipper plates turned up
for my Cobra:

A/ Diameter

B/ Depth from the clutch faces(where the spur sits)to the bit at the back where the shaft goes in/comes out(the flat that the spring presses on)
for each plate.

C/ What material do you think it's made of?Aluminium?,steel?,magnesium alloy?what?

Meaurements in millimeters if possible please.

I know Mardave have done one for the Cobra at £16.99,but plates done at work for free in ally or mild steel is a bit cheaper:lol:.
That clutch has a front and rear plate that sandwiches the spur gear between them.
I don't think(now I've looked)that an RC10 type(with the spur bolted to the
outside)would actually fit under the gear cover.

Mark