is anyone running a scrt-10 ? Please help

[iamdigger]

Just want to know what electrics people are running in this truck? Been told an ezrun 60a esc, 5000ma 2s lipo and a Traxxas Velineon 3500 Brushless Motor 540 can will be a good setup. But would like to know what other people run, especially if you’re running a 60a esc rather than the bigger ones.
EDIT'' and where can you get the cnc bits? and are there any must buy bits? I.E centre chassic braces.

Thank you

[hit5005]

hi im runing a scrt-10 ihave a novack 5.5 turn moter and gtb esc its spot on iv got a 7.4 5000 50c turingy pack hope this helps

[JonyNitro]

Just want to know what electrics people are running in this truck? Been told an ezrun 60a esc, 5000ma 2s lipo and a Traxxas Velineon 3500 Brushless Motor 540 can will be a good setup. But would like to know what other people run, especially if you’re running a 60a esc rather than the bigger ones.
EDIT'' and where can you get the cnc bits? and are there any must buy bits? I.E centre chassic braces.

Thank you


http://www.teamstrc.com/

bits from here, get a more amp esc will last longer, maybe a MMP by castle, or the new LRP sc truck motor

[Speeed Freak:)]

I run the flux 9t same as the ezrun with a 2s 40c 5000 mah lipo, plenty quick and normally top 3 in races, some guys run Real hot 550 motors etc but I still keep up!

Where you based?

[iamdigger]

hampshire, portsmouth / iow ryde.

[mattJT]

Well, I had my SCRT10 for all of one race before selling it on. For that one race I had a Novak Havok 10.5t in it and suffered the same overheating and cutting out mid race problem that I've read on here about for this truck.

Not much help I'm sure, but least tells you what didn't work well.