PDA

View Full Version : Orca Vritra VTC Pro Spec in a DEX410


Chris-S
16-05-2011, 11:20 AM
Looking at putting one of the ORCA pro spec ecs's in my Durango, has anyone got one to fit, as they are a bit bigger than an SXX. Running a small spektrum reciever as well. Photos would be good as well.

Stotty
16-05-2011, 12:15 PM
Bolton model mart sell these i think. I got the orca cheaper system for my 22. Dont know if it will fit durango but ino they sell them.

stegger
16-05-2011, 12:33 PM
ORCA VRITRA VTC TC PRO Spec MK2 Dimensions : 42(L) x 33.5(W) x 36(H) mm, with fan attached

ORCA new VRITRA VC4 PRO SPEC MK2 ESC Dimensions : 42(L) x 33.5(W) x 33.5(H)mm with Fan Attached

SP GT2.1 Dimension :
43 (L) x 35 (W) x 24 (H) without fan. With standard fan it's 32 (H)

I run the speed passion speedo mate and there's no problem, a was also running a futaba 2.4 RX aswell which was HUUUGGGEEE ! and it was o.k but tight :eh?: Gone to a micro spektrum one know though :thumbsup:
So going by the size's above you should be O.K. ;)

tomtom
16-05-2011, 04:48 PM
Just done that on my 410r this weekend, it fits
but I had to remove the on/off and put the small
Spektrum on 5mm spacers or so.

Will try to post pix, but send your mail by pm.

Thought the 22 was tight !

Chris-S
17-05-2011, 10:46 PM
Managed to get the speedo in, very tight, receiver needs sticking down and the wires shortening and its done.

http://imageshack.us/m/854/7555/22557710150180586431829.jpg