PDA

View Full Version : servo saver tightness? and another set up question.


Nigel
17-05-2011, 08:51 PM
i was putting together the servo housing and i noticed it dose not say how tight to screw this


http://i481.photobucket.com/albums/rr171/1slash/IMG_4038-1.jpg

how tight should it be?

and one more question.




is this a good very low traction set up?
http://www.petitrc.com/setup/durango...ts20100416.pdf

but it seems to be mostly a stock set-up tho.

because the track i race on is a dirt/clay track with bits of gravel in some areas and is not kept at all so its very low traction.

paulc
17-05-2011, 09:17 PM
It should be 1.4mm below the end of the sarvo saver shaft it's all on the Durango website http://www.team-durango.com/blog/?cat=3&paged=2

Big G
17-05-2011, 10:19 PM
mine's about a thread from the end. I found the 1st night I ran the car it came loose and it's a little pig to remove in a hurry.

I drop of threadloc and no problems since. Just had to remove it to install the alu arm and no problems tonight

Nigel
18-05-2011, 12:24 AM
oh ok thanks :) never saw that page.

and what about the set-up dose that one look good?

wacattack
18-05-2011, 10:45 AM
The link doesnt work

simoncrabb
18-05-2011, 07:26 PM
I personally have taken the spring out and threadlocked it solid...

Nigel
18-05-2011, 08:13 PM
oh sorry about that here this one should work.
http://www.petitrc.com/setup/durango/setupdex410/DEX410_HupoHonigl_PSVSalzburgAustrianNats20100416. pdf