Sx3 front diff coming undone

[The Chef]

Tried the Diff in both ways round and it keeps coming undone. Any Ideas?

[tyreman]

Have you put the locking screw in the ther side??

[The Chef]

i'll check now:lol:

[Dudders]

Have you put the locking screw in the ther side??

:woot::woot:

[Rich D]

i'll check now:lol:

Ive not seen an SX3 diff but it looks the same design as the Cougar on the exploded diagram. Make sure the locking grub screw is really tight against the thrust assembley bolt or it may come undone. Use two allen drivers.
The other problem that happens with these diffs is when you compress the circlip too much when installing the thrust assembley. If its right, then it should be very difficult or almost impossible to turn the circlip once its installed. They can slip out of position loosening the diff off if you have compressed the circlip out of shape.

[The Chef]

locking screw in thight:blush:

[bigred5765]

defo the circlip then in that case, tke it apart spread the cir clip open and put it back in make sure it in real tight

[The Chef]

Mint thank you guys. After nipping up the locking screw it seems to have not come undone.
:D