Schumacher mi4cx

[lukey1988]

What's the best chassis for indoor

What the best for outdoor

[h0m3sy]

2.5mm indoor

2mm soft weave outdoors

[lukey1988]

2.5 softweave ?

what set up for ardent droop camber ride height etc never reaslly been before is the 2.5mm better

[h0m3sy]

Just the standard 2.5mm chassis.
Try this set up

http://www.racing-cars.com/images/Technical_Info/Schumacher/Current%20Cars/Mi4CX/Set%20Up%20Sheets/MI4CX_setup_sheet_Chris_Ardent_rd2.pdf

[lukey1988]

would there be a lot of difference performance wise at ardent between the soft weave 2.0 compared to the standard 2.5m

[h0m3sy]

2mm soft weave would give you too much flex which could lead to too much grip. You could try it but use a 2.5mm top deck instead of the kit 2mm one.

[lukey1988]

i have through about using a 2.5mm top deck before but have not got one what would this do? less drip etc

[h0m3sy]

Less flex

[MattW]

We were running softweave (type) chassis toward the end of last winter at Ardent.

[lukey1988]

which chassis was the quickest one and what thickness was you using

[MattW]

The chassis I ran was a prototype 2mm softweave (slightly different weave - so not identical to production) and I think Chris G was running the production 2mm softweave.

[h0m3sy]

Did you run this with 2.5mm topdeck?

[MattW]

Not as I recall - can't be 100% sure, as I haven't kept any setup sheets!! I did run the 2.5mm std chassis at the start of the winter, but had gone on to soft weave by the end.

[h0m3sy]

We are due to go indoors and get the carpet rolled out again at the end of next month. It's interesting to read that you and Chris were using the softweave. May give it a try.

[MattW]

My intention will be to start indoor carpet running with a 2mm soft chassis.