View Full Version : What's difference between - Speed Passion GT V2.1 ESC Pro Stock & V2.1 EX Version
carlin
25-08-2011, 08:04 AM
Hi Guys,
I'm bit confused whats the difference between these two Speedo's
Speed Passion GT V2.1 EX Brushless ESC vs Speed Passion GT V2.1 Brushless ESC Pro Stock Edition
It's to run with my FS2 4wd on a 6.5t SP V3 motor.
The EX says ok for 2wd but doesn't mention what about 4wd it's more about running onroad 1/12th & 1/10th stock.
Any advice would be great, which model does Lee Martin run on his?
Thanks
baldric1983
25-08-2011, 04:39 PM
the 2.1 ex has a low profile heatsink and can run 1cell lipo with out a battery pack for the rx and servo, its for a 1/12th car
carlin
25-08-2011, 10:45 PM
the 2.1 ex has a low profile heatsink and can run 1cell lipo with out a battery pack for the rx and servo, its for a 1/12th car
Ah right thanks, so which one best to run in 4wd do I need fan too?
carlin
31-08-2011, 07:39 AM
I guess no body really runs these models in there cars?
Or SPassion ain't that popular nowadays.
I've took the plunge gone for this model to run in my 4wd with 6.5t SP V3 Motor
SPEXT98802SCB Speed Passion GT V2.1 Brushless ESC Pro Stock Edition
Fingers crossed :D
Timee80
31-08-2011, 07:55 AM
That model should have the turbo profiles loaded onto it rob but shouldnt really be needed for.your 6.5t. Handy to have anyway though. Buy the program box and then you can update and change firmware to whatever you like then.
carlin
31-08-2011, 08:02 AM
That model should have the turbo profiles loaded onto it rob but shouldnt really be needed for.your 6.5t. Handy to have anyway though. Buy the program box and then you can update and change firmware to whatever you like then.
Yeah I got a program box already a HWing one which works with the SP models so should be fine :D
shaun m
13-11-2012, 09:00 PM
sorry to drag up an old thread , can anyone tell me whats the lowest turn motor can be run with the 2.1 pro stock esc ....
knighthawk
13-11-2012, 09:37 PM
sorry to drag up an old thread , can anyone tell me whats the lowest turn motor can be run with the 2.1 pro stock esc ....
Found this on the Speed Passion Website !
Sensorless or sensored brushless
motor /
Supports up to 5.0T brushless motor
on 6 cell 7.2V battery, 5 cell with 4.5T
and 4 cell with 3.5T, 3 cell Li-Po
battery 9.5T above
note 2: Standard software on ESC
will damage lower than 10.5t motors.
Manual here:
http://www.speedpassion.net/uploadfiles/downloads/2010914154017GT2ProLPFGT21ProStock_ESC_User_Manual _Sept14th2010.pdf
shaun m
13-11-2012, 09:50 PM
ok cheers , was just wondering if that 5.0t limit is for on or offroad ..
discostu
13-11-2012, 09:53 PM
I run a 6.5 on my speed pasty pro stock in my 2wd no problems whatsoever
But follow the recomened guide lines and you'll be fine
knighthawk
13-11-2012, 10:02 PM
ok cheers , was just wondering if that 5.0t limit is for on or offroad ..
I'd say the 5turn is max and aimed at Onroad
I would say 6.5turn Offroad as the demand is higher !
But I'd temp check just to be sure !!
vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.