newbie coming to club - Durango tips.

[roary27]

hi there i am new to your club, i have a durango 410 what diff oils are best for front and rear, what pinion and spur gear to run and what motor is best for the track?

[mikeyscott]

hi there i am new to your club, i have a durango 410 what diff oils are best for front and rear, what pinion and spur gear to run and what motor is best for the track?

Have you raced before?

When I had a Durango (it's been a while) I ran a 7.5 on 87, can't remember what pinion.

I ran Ultimate oils 15k/10k I think, agfain can't really remember. Plenty of Durango people at the club that can help.

I run a Tamiya 511 these days and am very happy with it.

Mike

[dibble34]

I run 10k front & 5k rear. Gearing depends on what turn motor you run.

[mikeyscott]

I also ran 12.5 / 7k

Just to confuse I found Losi oil thicker than Ultimate racing, so make sure you stick with one brand of oil.

I never tried the thinner oils etc. It's an aggressive car so takes a bit of getting used to, I did do ok with it, but just prefered the Tamiya!

[roary27]

yes i tried it a few years back but didnt get on with the truggie i had etc. i ran a truggie at clanfield.

[hotrodchris]

10k front and either 5 or 7k in the rear
shocks i run 27.5 and 32.5 with losi oils
hope this helps

[jpmatrix]

Sorry to hijack this thread but would like to know what you guys would recommend for a 6.5t (gens ace) with a 87 spur in a dex410r.

I have also ordered the hobbywing 120amp esc. What settings do you run, timing, punch etc?

Cheers

James

[hotrodchris]

dibble is the program wizard for the hobbywing speed controller!
i run a 23 with a 6.5 v2 speed passion and a 120 hobbywing speed controller which was programmed by Dibble

[mikeyscott]

I believe SP & HW are same software. The Orion R10 also is similar which is what I am running. Just a shame about the price of the programmer!

[hotrodchris]

apparently the hobbywing software is better the programmer is only just over a tenner from hong kong

[dibble34]

Sorry to hijack this thread but would like to know what you guys would recommend for a 6.5t (gens ace) with a 87 spur in a dex410r.

I have also ordered the hobbywing 120amp esc. What settings do you run, timing, punch etc?

Cheers

James

21 - 23 pinion depending on speedo settings. i run the mod sp software now. happy to give you the settings

[jpmatrix]

21 - 23 pinion depending on speedo settings. i run the mod sp software now. happy to give you the settings

Thanks. Just received esc through the post today. Didnt come with the led program card. I have a speed passion program box that i use to adjust my sp lpf which has settings 1 to 15.

Can i use the sp program box to change the settings on the hobbywing?