PDA

View Full Version : Roll bar width


kaszal
01-09-2011, 08:19 AM
This is an unusual request, but can someone check the width on their DEX410 rear roll bar please?

http://i103.photobucket.com/albums/m134/kaszal/Durangorearrollbaredited.jpg

I'm looking for one that has a width of 57mm or slightly more.

Carlos69
01-09-2011, 08:44 AM
Approx 35mm ... I measured across from outside rear bulkhead roll bracket to the opposite side... the roll bars are a snug fit (haven't got an actual roll bar handy but from memory it's snug)

lcpvcce
01-09-2011, 08:46 AM
width same with yokomo touring kit roll bar size.........................:yawn:

kaszal
01-09-2011, 09:00 AM
Thanks! Did you mean the Yokomo bars were 35mm or 57mm in the centre?

lcpvcce
01-09-2011, 01:38 PM
I used it for my 410 ultra is 35mm for both-side front and rear respectively ............but the rear roll bar should be cut it off the end of roll bar edge for suitable length ...............:D

mattr
01-09-2011, 02:44 PM
Can you not just go to your LHS, buy some rod and make your own?