View Full Version : How many Cells with Mambo monster combo?
matt1981g
01-09-2011, 12:12 PM
Like I said with the mambo combo 2200Kv what would the optimum cell configuration be? I have a Ansmann Deuce with 2 Lipo slots what should i bee looking for?
2X2 cell in series
2X3 cell in parallel
2x4 cell in parallel
and what sort of Mah should I look for? with what C rating
Andy P
01-09-2011, 07:44 PM
The first question is:
bashing or racing?
bashing i would go all out that system will take 6s (6 cells in series) this will almost be undrivable racing although i have seen it done
racing 4s (4 cells in series).
C rating will depend on battery capacity. As this is the max discharge rate supported by the battery and your setup can take 150A i would aim for around 150A so say you go for a 4000mah bat you would want to aim for 35C plus battery pack. Discharge rate = C rating x Battery capacity.
As far as capacity goes 4000mah gives me about 10 to 12 mins racing.
matt1981g
02-09-2011, 05:41 AM
racing 4s (4 cells in series).
would 4 cells in series not supply 28v? or am I being very thick?:confused:
I now get the whole c and Mah now so I will start to look for some lipo's:)
5000Mah 30c as this is 150A
4000Mah 35c as this is 140A
Is there a place were everyone gets Lipo's from ? and what are the cheap and Nastys on eBay like? or should I just pay for some from a big brand?
I looked on Hobby king they seem good prices but a large cost for shipping to the UK?
Andy P
02-09-2011, 05:54 PM
1 Lipo cell is 3.7v nominal 4.2v fully charged so you are looking for a max voltage of 16.8v
so a 7.4v battery back is 2 cells.
Good supply of cheap good lipos is hobbyking 'Turnigy' I use these they have been fine.
vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.