Can Anyone Help Me Please lol

[Shaun 'TheSheep' Atkinson]

I am in bad need of the following to get My AE RC8B up and running:

Clutch Shim:
http://www.teamassociated.com/parts/details/89137/

M3 x 8mm SHC Screw:
http://www.teamassociated.com/parts/details/89223/

Clutch Bell Shim Set:
http://www.teamassociated.com/parts/details/89148/


Please PM me if you have any of these :)

[Sheepdog]

Ebay for the clutch shoe shimms dude
http://www.ebay.co.uk/itm/320482364582?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#ht_1361wt_1139

as for the screws and shims i dont think its too clinical to use the exact screws and any washers/shims that fit over the end of the nose cone but that are not bigger than the overal size of the bearing :)

[Shaun 'TheSheep' Atkinson]

Am I right in thinking then, That all you do is shim out the bell until it is flush with the end of the shaft?

[450kid]

no cause some times u have to put shims on the out side aswell, but shim it so it does'nt rub on the flywheel but so u have about 0.5mm end float.