Motor gear??

[corsa148]

Well just assembled the rear gear and have mounted it in the mm4 position but just giving it a few turns an feels a bit notchy an a bit stiff as u get to a quitter of a turn I have put the black gear grease in as states just wondering if it will bed in once run?.?

[Big G]

with a motor and pinion bolted on?

I found sometimes the mesh would be spot on in 1 spot on the spur and then turn it and it'd go tight. I think the motor plate wasn't sitting perfect.

[corsa148]

with a motor and pinion bolted on?

I found sometimes the mesh would be spot on in 1 spot on the spur and then turn it and it'd go tight. I think the motor plate wasn't sitting perfect.

No motor in yet taken it back apart thought I might of put to much grease in but was fine cant see any binding?

[Chris-S]

Make sure all the bearings are seated correctly in the gears. How many washers have you put on the diff outdrives?

It will take a couple of runs to bed everything in.

[corsa148]

Make sure all the bearings are seated correctly in the gears. How many washers have you put on the diff outdrives?

It will take a couple of runs to bed everything in.

Ye all seems sat right I have put the two gold washers either side as it shows with the other diff is this right??

[corsa148]

Also just got the wheels on without a motor in when u turn one wheel by hand the other doesn't always turn is this right:confused: