210 on polished floor/wood

[av4625]

Has anybody got any setups for polished ploor for the 210 on my first time out with it i had awesome back end grip but then turn in became an issue i was using mid 4 motor config i hav changed it to mid 3 for tomoro nite to try?

[David Poulter]

Has anybody got any setups for polished ploor for the 210 on my first time out with it i had awesome back end grip but then turn in became an issue i was using mid 4 motor config i hav changed it to mid 3 for tomoro nite to try?

Hi ya

You may find it easier to try the rear motor configuration if you are running on a low grip surface like polished floor. It will allow the rear of the car to slide more through the turn and provide much better steering.

It might be worth looking at Jorn's setup from the Reedy Race. I know it was on dirt but the grip levels maybe similar and certainly closer than compairing to an astro setup.

http://www.team-durango.com/pdf/setups/TD102006/West_Coast_US/DEX210_2012_Reedy_International_Race_of_Champions_ Jorn_Neumann_29_01_2012.pdf

David

[av4625]

Thanks!!!

[WHITTLER555]

Hi, I have to agree, the rear motor set up on slippy floors is the way to go, we ran at the York 24 hour race last weekend on a combination of slippy floor and carpet and I don't think we would have gone as well with mid motor.

[Big G]

I tried my 210 MM4 on polished floor and I couldn't push the car at all. It would understeer like crazy out of turns

[ghostdogg]

Hi Guys,
Try this to decide the setup?
http://www.team-durango.com/blog/2011/12/06/dex210-motor-configurations/
Oli