View Full Version : What happens when a GTB 'thermals'??
c0sie
31-03-2008, 02:41 PM
Does the ESC flash any LED's?
Does it just cut out?
How do you get the ESC to start working again?
Thanks in advance :)
Wraggy
31-03-2008, 03:04 PM
Not sure if this is the case on everyones , but Lee’s thermalled in practice yesterday and locked on full throttle … I have a nice burn mark on my finger to prove it as it caught the spur gear on full spin!!!!:cry:
markwilliamson2001
31-03-2008, 03:14 PM
Not sure if this is the actual case.... or proper instructions, but coming from IT, (switch it off and back on again) seems to be good advice. Doing an overall reset on the speedo (hold down the button on the switch when you turn it on) and do the full throttle and brakes etc etc.
Don't forget that you will need to reset your drag brake if you like it different from the standard setup.
Cheers
Mark
super__dan
31-03-2008, 03:34 PM
I've only done it once (Rich Lowe goaded me into running a 4.5 on long grass) and it just shut off. Kash turned it off and on again allowing me to do the 1/4 lap I needed to finish. It's been fine ever since too.
Chris Doughty
31-03-2008, 03:50 PM
Not sure if this is the case on everyones , but Lee’s thermalled in practice yesterday and locked on full throttle … I have a nice burn mark on my finger to prove it as it caught the spur gear on full spin!!!!:cry:
its not Nitro Paul, you don't need to stall the flywheel to stop a run-away! :P
Wraggy
31-03-2008, 03:53 PM
its not Nitro Paul, you don't need to stall the flywheel to stop a run-away! :P
HA Ha . it bloody hurt !!!!. i forgot about the slot under the chassis :thumbsup:.
still worked after though. just switched off and on again.
was down to a faulty fan which stopped, put a new one on and was fine all day ...
vBulletin® v3.8.7, Copyright ©2000-2025, vBulletin Solutions, Inc.