PDA

View Full Version : Saddle pack in a D4


Racingdick
02-04-2008, 08:18 PM
I have the D4 sitting on the shelf almost ready to go, just need tyres and a steering bearing after the original went walkies somewhere.. :confused:

Im not really wanting to get my cells redone to fit so want to go trakpower lipo but haven't seen a photo of one fitted but also want to know the best way to go abouts securing it in the car, this seems good but B44 only
http://www.redrc.net/2008/03/diggity-designs-b44-lipo-mount/

telboy
02-04-2008, 08:29 PM
It wouldn't surprise me if that fitted the D4 too. They are very similar cars.

?? Anyone got both cars, or had both cars and can compare the holes etc on the chassis?

dan_kitty
02-04-2008, 08:59 PM
the trak power saddles wont fit the d4 unless the top deck is raised, apparently by 1 mm or so.

im guessing a few washers would do the trick

leelar
13-04-2008, 10:13 PM
I have seen a photo of a D4 with Trackpower lipos in but was not sure how can someone help please

mark christopher
14-04-2008, 08:31 AM
raise top dect 2mm with spacers and lift the battery posts to suit, i got some carbon straps for mine

telboy
14-04-2008, 05:25 PM
Is that with the plastic cell trays removed?
I assume it is.

Is it poss to 'shave some off of the rear topdeck to make them fit?

mark christopher
14-04-2008, 05:59 PM
Is that with the plastic cell trays removed?
I assume it is.

Is it poss to 'shave some off of the rear topdeck to make them fit?
trays removed
pic attached

tell top deck makes no change lifted up, i even made the A at worksop with it raised!
if you looks its lower than the front any way

Racingdick
14-04-2008, 08:30 PM
how did you stop the side to side movement of the cells? where did you get the carbon strap from

:thumbsup: thanks for the pic

mark christopher
14-04-2008, 09:01 PM
i made em
fibrelyte have pattern for some better ones ill find some pics later

Ian F
14-04-2008, 09:09 PM
If you only have one pack try servo tape and turn the straps around, should stop the side to side movement.

mark christopher
14-04-2008, 09:29 PM
or i did use stick pack heat shrink and shrink the straps to the cells

mark christopher
14-04-2008, 09:29 PM
If you only have one pack try servo tape and turn the straps around, should stop the side to side movement.
std straps ar too tall then body wont go on

Jeremy Blair
14-04-2008, 10:18 PM
A friend of mine here in the US runs lipos in his D4 and he just grinds the cell grooves off the bottom of the straps. Here is a pic of his car.
later Jeremy