PDA

View Full Version : fitting mamba to gb-01


dan_kitty
02-04-2008, 11:25 PM
quick question, what pinions are people using on a mamba motor/gb-01 setup

I was just trying to install it into the car but couldn't get the stock pinions onto the shaft. Do i need different pinions? or should i drill out the hole a bit to make it fit?

didnt come with any motor screws either so i need to find some of them as well as the tamiya ones are the wrong size for it.

ta

frogger
03-04-2008, 08:17 AM
Associated RC18 pinions works a treat. They are 2mm shaft and the correct pitch.

I run a 15T on a 5400kv motor with 7.4v or 15T on a 4100kv with 11.1v.

dan_kitty
03-04-2008, 12:49 PM
thanks for the feedback:)
gonna order some of them pinions
ive been looking through the net but cant find any ref to what size mounting screws the mamba micros take. Im in work so cant measure the holes

any ideas?

thanks

dan_kitty
05-04-2008, 12:01 PM
yay, my bits arrived this morning, fitted a 12t rc18 pinion to the mamba 8000k/11.1 setup, been ragging around my shed...awesome!!

only problem is the gear cover doesn't fit on without binding the pinion. So ill have to drill a hole in it, unless there is a third party one with more room?

still waiting for the 3racing shocks though, so its still in gerald mc boing boing
mode.

servo response is much better than i imagined, and i like the way you can turn it on and off from the top of the car.

looking forward to making it race worthy, happy days

ta

killaj
06-04-2008, 03:22 PM
Rather than drill a hole in the cover, use washers or a rubber o-ring between the cover and the gearbox so that it clears the pinion.

jamesban
16-05-2008, 01:05 AM
The problem for me is the holes do not line up at all to mount my mamba in my mini fox. How did you get yours to fit please?

twisty
16-05-2008, 11:41 AM
When i fitted my Mamba i had to open one of the holes up a tiny bit on the motor plate.
If you look at the mounting holes on the motor,there are different distances,offer up the widest ones and you will see how much the plate holes have to be opened,it`s only a tad.