Go Back   oOple.com Forums > Members List

Charles Charles is offline


Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. Charles
    Thanks for the tips i will look into it ...
  2. Adam Skelding
    Adam Skelding
    You can back off the lock. But I've not ever had to do this.
    Best thing to do is to check that there is a 2mm gap between the ballstuds on the Ackerman rod. I use 4x0.5mm washers to do this, is stops the ball ends jumping on impacts too. Make sure you are using the Durango servo horn for the car, it's the length it is for a reason. If you are using the +5 castor blocks to get 30 degrees, you'll need about 3-4mm of washers under the ball stud on the knuckle. If the rest is built to manual, you should really be having no problems. It could be that your servo is over throwing. Just check you are getting full lock on the bump stop and you'll be fine.

About Me

  • About Charles
    South Africa
    Favorite Music
    Good old Rock
  • My RC's
    List of cars raced / owned
    Cars you currently race
    Durango Dex 410
    Dex 210
    Sticks or Wheel


Total Posts
Visitor Messages
General Information
  • Last Activity: 26-01-2015
  • Join Date: 16-09-2009
  • Referrals: 0

All times are GMT. The time now is 04:42 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.