T084 Axle dimensions (Procat)
 

I'm fabricating a couple of these... can't bear to pay what people are asking for them! If anyone has a spare that they can measure I'd be eternally grateful (well, that's my story anyway!) Well that should read 'silver' not 'siver'.

I need:
A: Overall length
B: length of reduced dia - I assume this is to allow the thrust bearing a little room to self-align?
C: Threaded section length.

http://imagizer.imageshack.us/v2/800...540/aAowi7.jpg

I'll try and remember my vernier from work tomorrow, and get one measured up for you.

Just a little reminder on this one, measurements please.
Jools

You could buy the one I have and measure it if you like!! :D :D

SlowOne I wouldn't mind that if the cost is reasonable. The most recent I've seen for sale is not cheap, but worse, they want 30 bucks to post it to OZ (I'd be amazed if it actually cost more than 10 bucks to send).

Apologies for delay - a lot going on at home and work at the moment,

A = 39.5mm
B = 4mm
C = 9mm

Note that there is a small shoulder before section B, about 1.2mm long and same diameter as main shank, to centre the spring washers, 4mm length includes this.

Cheers,

Dan

Brilliant Dan, now I can make one or two.