K1 loads quicker than sx3???
Hi,
I've just raced a Cat K1 against my SX3 they both Have nearly same setups. The only difference is mine had a SP 5.5R and the Cat K1 had a Orion Vortex 5.5T. The rest is exactly the same. I did notice that the K1 has a 98 spur gear on and mine had a 82. But the SX3 only goes upto a 90 tooth. The K1 was stupidly faster than mine and I just wondered if its down to the car or its the Gear setup? Has anybody got any advice? |
You would have to work out the final drive ration to really compare, but with running both, the K1's drivetrain feels a lot freer than the SX3, mainly due to there is a lot less rotating parts/belts.
|
The K1 does seem to accelerate quicker than a SX3 and seem to be a bit quicker. But without knowing what pinions your using it's hard to know what the difference could be. In general I've found that the K1 needs to use a smaller pinion than would be fitted to the SX3 to acheive the same gearing.
|
Cheers for replys.
Sx3 is using 82/20 K1 is using 98/20 Do you think it could be the motor difference? |
Motor speedo battery all need to be the same
|
I had a SP 5.5, It was pretty slow comparing to my Redline 5.5.
Ive had two SP, and they have always been slower than Redlines & X12's like for like in the same car. They seem to lack punch, Although I thought they felt better in 2WD's |
It also could be down to turbo/punch setting on the ESC.
|
I will check turbo/punch settings.
It does seem to be in a different league in a straight line So may have to change the motor. Thanks for advice |
I have transfered two motor speedo combo's to a K1 from an SX3 even down to the same pinion and the K1 is much faster. No changes at all!
|
Quote:
|
All times are GMT. The time now is 01:59 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com