LRP Sphere "clitching" under acceleration
 

I run a sphere which has developed a clich when it accelerates. I have tried resetting it and resyncing my radio gear but this has not helped.
Any advice greatly recieved

Sensor cable.
Sensor board.
Motor wires.
That's what if be looking at in the event of glitching.
Could have a short or fault in any of them

Had the same problem with a HW 2.1 XErun, no matter what i did id get a glitch under low throttle application.
In the end it turned out to be the servo/esc combination, even with a power cap it had the problem, ended up swapping out so much stuff, i bought a new esc and servo, try swapping out a lower draw servo first though!

lee