Indoor motor
Need a bit of advice, whats gonna be a good BRUSHED motor for the winter at Os? Am thinking an 11x1 might be a little too much.
|
I always liked 12 or 13t indoors back in the brushed days :thumbsup:
|
I prefered a ten double. Down to what you prefer. Major torque use a ten, more of a relaxed accelaration and more top end use a 13d
|
Have you raced indoors at Oswestry before ?
If not, then its not that big and you can get upto 30 laps in the 6 min heat (depending upon track layout). I run a 10.5 brushless with lipo and its quick enough. I have run a 6.5 and spent most of the time trying to keep the car in a straight line. :lol: |
Phil, Its been a while since I ran indoors, I assume its similar to how frodsham was back in the late 90's since that was when I ran indoors last.
Think for safety I will stick somit slower in, just until I have seen layouts grip etc. |
I'm looking forward to this on Thursday as I only have 7.5 slowest!!!!
Should be fun! |
what surface do you race on?
|
Carpet, unless the moths have eaten it over the summer. With patches of old wooden floor where the carpet is not long enough.
|
Me and ash will be at the club from about 11am to start tidying up indoor and try and get the rostrum up and the carpet down.
|
When and how often do you guys race at oswestry? how many heats/rounds are there too?
|
Every thursday night starting at about 7 we normally have 3-4 heats of about 6 or so cars
|
Anyone know someone who can skim me motors?
|
I could, but I'm in Leominster (HR6)...
|
ill see if i can get someone to bring a lathe down for ya mate and ill do it for ya. just hope they still have the lathe handy at home, BRUSHLESS BABY!!!
|
I know adam has a lathe if you ask nicely im sure he could do it for you.
A |
Cheers Mike, i've got a collection that needs doing :) should keep you busy tonight :)
|
Lathe
Mike i've still got my lathe and checker so will bring it with me tonight
|
awesome J thanks :p ill have to go to the cash point for ya before i come down
|
All times are GMT. The time now is 10:11 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com