no shims on front hubs on b44
 

after stripping my second hand b44,i noticed there no shims between the hub and bearings or outside between hex and bearing.looked on part diagram and non shown.surly there should be some in there as the rears.

nope none listed for the front :-)

Let's go back a step.... Can you describe (or photo) the full assembly? I'm just wondering if you've got the hex in the wrong place.

if you have a look at ae parts listing
http://www.teamassociated.com/pdf/ca...am/cat_b44.pdf

it clearly shows the hex and the wheel nut in the wrong place.no probs there, have worked out that . just not showing any shims between the cva and the hex with pin.so as the the shaft gets pulled in and out the hex rubs one way and the cva rubs the other way on the wheel bearing.