Schumacher 14mm wheel hex U1408Z
1 Attachment(s)
Hi All,
Please could you help me with trying to find a pair of 14mm wheel hex's part number U1408Z to fit a cougar 2000. Your help with this would be very much appreciated. |
I can’t but could someone 3D-print one if necessary
|
Pre 2017 Xray hexes were 14mm - would they do the job?
|
I am not sure if the Xray ones will fit. There are a few options for 14mm hex but from what I have heard people have not had much luck fitting them to the Schumacher cars. I think it messes up the offset of the wheel by all accounts.
I am hoping and praying I can source some genuine parts as this one is going to be a shelfer with maybe a few non competitive carpet runs as I like to use the cars. |
schumacher hexes are a taper fit on shaft so I don't think any think else will fit
I'll look in our spares see what we can find do you know correct thickness of originals so I can be sure regards Dave |
If they are the same wheels as the Cat 2000 i'm pretty sure I bought some off Schumacher's website, alternatively take a look at Wheelspin models or Schumie spares
|
4 Attachment(s)
Quote:
Hi Dave Please see the attached pictures I have showing the thickness of the wheel hex. I have taken two measurements as there is a raised edge in the centre, on the reverse side of the hex. Your help is very much appreciated. Regards Andy. |
Quote:
Hi Lofty They are the same as the cat 2000. I have tried everywhere to try and find some including the sites you have mentioned in your reply but to no avail. I saw some on ebay a few months back but lost out in a bidding war :cry: |
fairly sure I have a pot with a few in sorry I'll try look tomorrow
cheers Dave |
All times are GMT. The time now is 03:12 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com