View Single Post
  #80  
Old 23-08-2009
Mossy Mossy is offline
Senior Member
 
Join Date: Feb 2007
Location: Stoke
Posts: 553
Send a message via MSN to Mossy
Default

Here is the setup i finished on at the Euros

Front -

Track Washers - 1mm front and back
Roll Bar - yes - 1.2
Shock Position Mount - Middle
Shock Position Wishbone - Middle
Front Rake - 10 Degrees
Washers - 0mm
Front Link Bracket - 37mm
Washers on Hub - 0

Rear -
Wheel Base - Long
Toe In - 3mm Rear, .5mm front = 3.25 degrees
Anti Squat Washers - 2mm Rear, 0.5mm Front = 1.8 degrees
Rear Link Bracket - 37.5mm
Washers - 4mm
Shock Position Mount - Inside
Shock Position Wishbone - Inside
Hub Postion - Middle
Roll Bar - yes - 1.2


Shocks

Front -
40wt on 3 Holes drilled 55s
Schumacher old Grey Springs
Diaphragm - Centre cut out and removed
Ride Height - Wishbones level

Rear -
37.5wt on 3 Holes drilled 55s
Schumacher old Red Springs
Diaphragm - Centre cut out and removed
Ride Height - Wishbones level

Transmission-
Rear Diff Height - Low
Front Diff Height - Low
Layshaft Pulley - Pin Through
Front Drive - Diff
Gearing - 83 x 24 on Speed Passion 4.5 (ran a 5.5 when the temperature came up)
Internal Ratio - 34 Tooth Pulley

Tyres
Yellow Mini Pin all round, Mr O Foams.

Any questions ask away. This setup was good all week.

Si
__________________
Schumacher, Hobby Wing, Thunder Power, Anderson, Sanwa, Trishbits, P-Dub Racing, Rudebits, Inside Line, Nuclear RC, RC Domination, RPC
Reply With Quote