Hi Matt,
thx for the answer. I found 2 "ultra short" ball grippers in my box.
BUT!!
Please have a look at the figure......
The mounted ball grippers are already the ultra short ones.. 5,4mm shorter than the standard ones.
--> no result. Or will you even shorten these ones?
The spring cup adds -maybe- 1 mm.... I don`t think, that this will help.
So, for shortening the shock I run out of ideas...
How is Tom getting these 18mm? BTW: it works great with the medium springs.... But then, you have the effect, that the spring becomes loose, when the shock absorber is on full length. So, this is not a result.
You are right, shortening the shaft will primarily reduce droop, not the ride hight.
I will use the pin wholes in "high" position and measure then.
|