[neallewis]

Originally Posted by ReneT

If I try to measure offsets it's within 0.2 mm among those. It's all about 26.7 mm. (give or take 1 tenth). That's from inside of the rim to where the hex touches the wheel. They all seem to be the same.

It's actually kinda hard to properly measure the offset correctly, I press a hexdriver down across the wheel and use a caliper. Then substract the with of the hexdriver.

I see. I thought the offset was much larger. I will borrow a set and measure myself. I would like to run hexes on the rear so i can easily share wheels/tyres with my bmax4iii, but swap back to pins when i need to use decent tyres on pin wheels like holeshots for RHR dirt, etc.