[neallewis]

Originally Posted by corkyjohnson75

Can you put a pic of it on Neal .

My B max is very noisey from the spur , any idea how to turn it down o notch ?

Sure I'll try do one later.

Yeah the spur noise has been covered earlier on this yea in the main Bmax4III thread. There is a bit of bearing slop in the slipper motor pod. With the top plate off, place some squares of tape on either the top of the bearing edge, or on the underside of the top plate where is will make contact with the slipper bearings. This packs out the bearings in the mounts and stops the movement and noise.
I noticed the newer centre mount (B4-304C2) that comes with the lightweight chassis is a much better fit around the bearing.