Quote:
Originally Posted by isobarik
So rama the anser would be that you have to make an
B4slipperlayshaftwithpinnedpulleysfor the lazer zxr 
Mvh isobarik |
naah i am gonna try one piece double pulleys.
The side near to spur will have full length splines, because it is possible to do so here on the layshaft.
As for the one way end, the splines must be shorter but i have lengthened the splines just a tiny bit.
There is also a 4,5mm thick guide in between to take up the gasp left by removal of thrust bearing.
I am however unsure of the pulley spline size and accurate shape so i guess this will have to be done a few prints before getting right.
Another idea i have is to make this pulley 1 tooth bigger, 15tooth, it should fit well as the belts are a tad loose anyway.