Quote:
Originally Posted by Austin-1275
Ive stripped it down to check for poor or incorrect setup and all is consistent.
Any ideas.
|
Strip it down and check more carefully.
Do all four suspension arms swing completely freely, no bent pins, shocks absolutely even left to right, nothing touching or otherwise binding on the drive shafts, nothing touching the diff (burrs inside the gearbox) no gears cracked or bearings binding/worn out, all the right spacers in place (between bearing pairs, does the B6 have crush tubes in the hubs?), chassis not twisted? Half shafts put together properly (some have two possible set ups, long or short, others have two set ups, wrong and right....... a mismatched pair will make life exciting) nothing overtightened (can overtighten wheel nuts fairly easily, makes the wheel bind on the hub in some cases.)
I had the same on a B4.1, spent ages chasing it round the chassis. Was a very very slightly bent rear shock shaft. So under acceleration the car was squatting cockeyed and taking off sideways. Had to lie down on the floor behind it and watch..........