Kevins right, the Rs is in dual mode as a default. Look towards the right side of the Hotwire interface in the middle and you should see a box that says "Sensored only." If you want to run sensored only you must click this box.
If you had 122F as a motor temp that's more than fine. I'd say you could gear up if you wanted to.
DCM is spot on though as far as esc temps are. The solders posts are our "heatsinks" so don't touch! LOL
Check the internal temps just like DCM said, that's all I care about. In wheeler on high bite you should see around 5 or 6 led's in an RS Pro running anything hotter than a 6.5.
If you are getting to 7 led's you are either overgeared or need to get some air into your shell. If this can't be done well use a 2nd cap.
|