hello this is a project I'm working on its called the INSPIRE4
+++ INSPIRE4 spec list +++
*Quick diff height adjustment, just loosen 3 screws on the chassis and slide a shim under the gearbox also easy to remove the whole diff case with the same 3 screws without affecting any of the suspension .
*Quick diff change without the need to remove the whole diff case or affecting any of the suspension.
*Low diffs front and rear. ...
*Left-right, front-rear wishbone are the same complainants.
*Front and rear bulkheads are the same
*The buggy has the lowest CG of any other rc buggy on the market.
*Adjustable front kick up and caster.
*Adjustable anti-squat plus the option to run pro-squat.
*Inboard suspension design with the dampers mounted as low as possible.
*Easy adjustable rocker ratio.
*Unique to the “INSPIRE4” a cross over quad rocker rear suspension system.
*Suspension geometry designed from scratch.
*Quick release spur gear.
*Chassis layout to achieve a 50/50 weight distribution (depending on electronics).
*Adjustable chassis flex
*Large angled side pods to increase ground clearance when the chassis rolls through the corners and decrease the chances of chassis rub.
*Flat chassis design
*No shock towers to disturb the air flow to the wings and body shell.
*CFD software used when designing the car.
*Minimal weight passed the front and rear axles.
*Wings mount perfectly over the centre line of the axles.
check out its facebook page
https://www.facebook.com/MRO-Racing-757539404314286/