hiya all have just seen this. my setup from the petit (from memory as the car isnt here at the moment) is as follows
FRONT
oil 40-45 wt losi dependant on temprature
piston 2c
spring lime green 75
shock tower kit middle
wishbone outer hole
inner camberlink middle hole +1mm washer
outer camberlink inner hole
hub height low (washers above)
kickup 25 degree's
weight 20g on top of servo 20 on top of square bit of the battery strap
ride height wishbones below level
REAR
08 velvet body, 54mm shaft
oil 30 wt losi
piston 3b
spring mauve,blue (imt told 72 but not sure, spring that comes with the 08 rear end)
shock tower 08 middle
wishbone 08 middle
inner camberlink outer hole no washers
outer camberlink outer hole +2mm washers
08 hubs medium wheelbase (no height adjustment)
rideheight driveshafts level
wing in middle mount position
NOTES
shoulder cut off the front pivot balls for rear wishbones, 2 white washers placed behind wishbones to shorten wheelbase, tekin 3400 lipo in forward position
kit wing with half gurney (flies very neutral)
car very easy to drive with bundles of steering, fronts have outside and inside rows cut off and rear minipins run full with mr O medium foams,
8g over weight limit
this setup is for high bite carpet with large jumps only as the oils are to thick for normal use. see setup on page 2 for normal use.
any questions feel free to ask
__________________
Nathan Ralls HPI, Custom Blitz, www.piraterc.com mr-o foams
woop woop racing officialy keeping team toe out inline
|