Thread: Lazer zxr
View Single Post
  #2841  
Old 02-04-2012
Welshy40's Avatar
Welshy40 Welshy40 is offline
Spends too long on oOple ...
 
Join Date: Sep 2006
Location: .
Posts: 4,772
Default

After some discussions with Fibre lyte we have an idea for making a block to do the job.

It fits directly above the front gearbox holes that are by the pivot block. The idea is the block will have two holes drilled into it by fibrelyte (bigger so a brass tube can be cut to size and glued within the block giving strength) but then they will make me a jig so that I can drill the side as I will be going against the grain. Then when done I should have a brass tube cut and glued in to give strength and then bolt to the chassis. This should also stop some dirt getting in as well and shouldnt be too expensive either.

I am also looking at the pivot block in CF as well (I designed and tested these twelve years ago) and will when happy get these posted on the website with all the other extras.
__________________
www.kamtec.co.uk
www.fibre-lyte.co.uk
answer-rc.com/uk/en/
Answer UK team driver
Designer of the Lazer ZX/ZXR carbon fibre tub chassis
Designer of the Lazer ZXRS
Reply With Quote