Here is my completed M18T Pro (for the most part).
Body is pretty fugly, but I had to give a call out since I did get some oOple stickers on it (almost felt like a shame doing so).
You can see my wing mounting system, and smaller servo as well.
For those who decide on the flight power lipos, they are thicker, so you will have to add shims under the battery retention posts. Otherwise they drop right in.
It has
Electronics:
- Tekin Rage w/ latest firmware (smmoooth)
- Aon 4900kv (temp)
- FlightPower 1600mah 20C 2 cell lipo
- Spektrum Micro Receiver
- MRT PTX Micro Transponder
- Extra Power Cap
- Hitec HS65MG servo (temp until 5065mg becomes available)
(see the picture of the glowing bits )
Hop Ups:
- Carbide Diff main and thrust balls
- Xray Aluminum Shocks
- 3 Racing Aluminum Bellcrank
- Xray Blue Sealed bearings in hubs
- Yellow Rims
- Losi Street Tires (good for carpet racing as well)
- Anderson MB4 molded wing
- Custom tower wing clamp and AE wing mounts
- Rubber booties on shocks (party balloons)
- T-bone Racing M18T Racing Bumper
- RCScrewz screw set (not recommended considering the modifications I had to do to get them to fit in the metal pivots)