Here is what I did in the past to use the Rulux wheels on my TM2V1 and it did fit in the box. You need the TC02C hubs, drill out the TM2 rear arms (outside) with a 3mm drill (not completely through) and the rear pivot pins from the TC02C. Take the AE style axles, replace the cardan with 63mm from the TM2 and do not forget a crunch spacer between the bearings (I use the inner race of a worn hub bearing). For the front I used the B4 trailing steering arms drilled with a 3mm bit and put a 2mm spacer on bottom or top dependending of the needed droop (I always put it on top). Now I do not bother anymore and just use the 12mm hexes and wheels.
|