After some discussions with Fibre lyte we have an idea for making a block to do the job.
It fits directly above the front gearbox holes that are by the pivot block. The idea is the block will have two holes drilled into it by fibrelyte (bigger so a brass tube can be cut to size and glued within the block giving strength) but then they will make me a jig so that I can drill the side as I will be going against the grain. Then when done I should have a brass tube cut and glued in to give strength and then bolt to the chassis. This should also stop some dirt getting in as well and shouldnt be too expensive either.
I am also looking at the pivot block in CF as well (I designed and tested these twelve years ago) and will when happy get these posted on the website with all the other extras.
|