Actually It's not that bad.
First you need the whole assembly of Losi arms hubs ....
The you take the bulkhead and remove at the arm mount about 1,5mm from the front till its flush with the rest of the material.
The rest of the fitting is done from the rear end you will now need to remove almost the entire thicker rear part of the arm mount.
Now fit the bumper and then dremel the front of the bulkhead so the arms have their needed play.
Pins are a direct fit and forget about the E -clips at the rear as you will keep them loosing anyway.
Now you need the steering arms.
You will need to have the two holes in the front version but the outer hole upside down.
So take the arm, place a c/f plate on top dremel the outer shape ,drill the hole through and then remove the outer plastic part so you can mount the ballstud directly into the c/f part.
You will now need a slightly longer center track rod an a pair of lost shockbottoms and your'e done.
