Quote:
Originally Posted by hide
Thomas how did you solder new wires to the Mongoose motor? Thanks
|
Quote:
Originally Posted by Thomas P
Hi J, i have cut them only 2-2.5mm from rear end of can..and just taken of the protection yellow,orange and blu silicon"cable..so only the cables are out, as short solder tabs..so i can se the collor, still "inside" the holes where the cables are in..
not sure if it can be seen here?
|
well done thomas. I did that same thing to mine a long time ago, as it's basically "straight-wiring" the motor ... and so as to eliminate the extra 9 connections of the motor bullet plugs that have a propensity for failure, and poor connections which hinder operation and performance