Foam Tyres & Additive
---------------------------
Quote:
It is not necessary to absolutely soak the tyres in additive until they are dripping. A dipped brush full
for each rear tyre is usually plenty, and about half a brush full for the fronts. Do ensure that you get an even coating to allow it to soak in to the foam properly.
|
Fronts
from the inside edge apply for 1/4 width and go from there. More width gives more steering. Apply lightly, they don't need to be ringing wet
Rears
full width all the time and wet but not dripping
Try to apply rears addy at 20 minutes before applying front
Foam
Make sure you have a radius on the inner and outer edges.
Some good info in here
http://www.brca.org/sections/subsect...-articles/1144