anti-squat
in the manual it says you can change anti-squat from 0-3degrees but does not show you how.
obviously to get more anti-squat, I need to raise the fore side of the rear pivot block, do I use 0.03 shims like on the AE?
EDIT....found a setup sheet and saw you can put washers under the rear pivot block,
does that mean the standard setup is 3 degrees anti-squat? And putting washers b/n the rear bulkhead and pivot block will reduce antisquat? If so, how many washers gives what degree of anti-squat?
it also says 4.5 degree anti-squat is possible with additional parts. Is this a new rear pivot block that sits the hinge pins lower?
What parts do I need for 4.5 AS?
|