Quote:
Originally Posted by t8rtot
can i get at least a baseline setup for a med/high grip indoor clay tracks. we're using aka rebars, barcodes and bk bars for tires. and as far as the rear aluminum hubs go, what differences will i see from 0-0.5-1deg?
your a champ Lee  |
Of course; start with:
35wt front - blue spring - 1.3 x 2 piston
Middle hole on the arm - 2nd out on the tower
inside hole on link with 1mm washer - 3mm washer outside.
30wt rear - yellow cut spring (1 coil off) 1.4 x 2 piston
Inside hole on arm - 2nd out on tower
try meduim wheel base.
with regards to the hubs:
the more toe in you have - the more rear side bite the car will generate.
the less, the looser the rear end. sometimes you can even turn the .5 blocks around so overall you have 2.5 degrees of toe in. this helps the rear end pivot on slow twisty tracks.
lee