View Single Post
Old 07-11-2007
biggusditchus's Avatar
biggusditchus biggusditchus is offline
Join Date: Nov 2007
Posts: 14

I bought a Tamtech Ferrari kit and in the kit was a set of adaptors for 12mm hexes so that was rear sorted. On front the bearing diameter is smaller on Buggy Champ than on other Tamtechs it uses 850 bearings so I used a Tamiya Mini rear axle with a spacer on inside, simple then to add a drive pin, hex and bolt up wheel. (just ordered an alu axle to reduce weight as the steel mini axle is heavy.)

In first photo I didnt have the mini axle fitted, tried something else bout couldnt get wheels centered properly.
Reply With Quote