Ok stripped it down and definitely not the circlip as that was still in the right place.
I noticed that the two bearings on the male part of the diff were in the wrong order - 3.0 bearing switched with 2.5mm bearing. Could it be that causing it to undo?
Otherwise how about the stack being wrong inside the diff, i.e. maybe I got the tiny disk that goes between two bearings at the end of the spring stack the wrong way? (because frankly I couldn't see any difference in them when assembling.
Think I need to buy some circlip pliers if this doesn't work. Shame schumacher just deleted them out my last order and told me to order again last time. Would have preferred the choice of delaying rather than paying postage again...
|