Thread
:
Yo-clone-oh Dogfighter YZ-834b
View Single Post
#
20
18-08-2019
Dadio
Member
Join Date: Jan 2016
Posts: 270
Just a bit of fun , i modeled up a rough copy of a Bolink Funco half body , its not quite right , the cab is too long , this is printed in Vase or Spiral mode , just one layer or 0.4mm thick , printed in PLA as a test print so its quite brittle but it covers it over for now , only took 4 hours to print .
Dadio
View Public Profile
Send a private message to Dadio
Find all posts by Dadio