Thread
:
Durango Hex Modifications
View Single Post
#
1
29-01-2014
Dino_D
Member
Join Date: Feb 2012
Posts: 40
Durango Hex Modifications
Tired of loosing those pins on your DEX210 or DEX410?
Hopefully the admin can make this a sticky or add it in the tips and tricks section.
Just made a few mods to the existing wheel hex. Thought I might share it with you guys. You just need part #704046
Test to make sure the screw sits flush in the hex or the wheel can't fit on.
You need to shorten the pin slightly so that the screws can clamp onto the hex and not protrude out. If you can't put the wheel on, either the pin is too long or the holes for the counter sink is not deep enough.
Trim any flashing so that the pin can slide in easily.
Dino_D
View Public Profile
Send a private message to Dino_D
Find all posts by Dino_D