Quote:
Originally Posted by Col
Excellent thread. Made it sticky for a while  |
Cheers chum
I hope it helps some people out.
EDIT TO ORIGINAL THREAD -- Everyone please note, that after converting another KO Propo Esprit II and a Sanwa Exzes tonight, I have changed my advice. I have changed the original post, and highlighted this in red.
Also, adding a bit more info as I learn it myself:
The little daughter board with the BIND button and LED seems to be different distances between the button and the led from board to board.
Ive fitted 5 of these systems now, and so far, 3 have been the same (and fitted the template Ive made for drilling) - however, tonight, I noticed that the button and LED were 1mm closer. If I had drilled the holes without checking, the end result would have looked nasty.
So my top tip is to check your measurements before drilling. I think the difference is down to the components being soldered in at an angle to the daughter board.
If I get a chance over the next few days, I will draw my template into Photoshop and post it up here for you.
HTH.