Quote:
Originally Posted by Danosborne6661
They're no far off though, you'll notice near to no difference between them on a big straight.
Like others said, check your end-points (note some go to 150%, so if you have it set to 100% you're only getting 2/3's of your power), reset-up the ESC, full timing on the end bell and you'll be well on your way
|
Just to stop confusion for people reading this. Even if your transmitters end point goes to 150%, you can have it set to 100% as long as you configure your esc with it set this way. If you do this, you will get 100% throttle.