Thread: Cat K1 Setups
View Single Post
  #30  
Old 31-01-2013
Cruise's Avatar
Cruise Cruise is offline
Member
 
Join Date: Jul 2007
Location: Augsburg/Germany
Posts: 261
Default

If you want to get the rear pin higher you will sometime hit the point when you canīt remove more washers.That will most likely happen in the front,so you put that one hole higher.As you want a short stack for bending reasons you leave the rear in the lower hole.


Cruise
__________________
Team CS-Electronic
Team Schumacher
Reply With Quote