So to start with the tare down after my new chassis arrived. This is made from 3mm thick carbon with the gearbox part milled down to 1mm to protect the plastic box from hitting the ground unlike the original.
So cracking open the box four it to be fully ballraced unlike the other box I’ve got that’s just got bushing in, it also has the early (apparently) greenish gears. But there all in really good shape and so is the rear diff.
While embarking on this build I’ve been searching for one of these RPS slipper/toque limiters
As luck would have it one just appeared on eBay and with a resnable offer accepted it was on the way to me.
