Quote:
Originally Posted by J77MYF
One of mine did exactly the same when I built my kit from new the other week. If you are careful you should be able to put a line across the damaged heads with a Dremel and then use a flat bladed screwdriver to get them out. I replaced all of mine with new screws which then allowed it to tighten up properly. I bought 10 of these in size M2.5 x 10mm which are exactly the same size and colour as the originals:
http://www.ebay.co.uk/itm/M2-M2-5-M3...OJbIxPQ2q2uJ5w
Hope this helps
|
Massive help mate, ta. I just ordered a new gear diff and a set of those screws